Step 1: Install Bulkhead Adapter
A. Remove the forward upper Tie Down Brackets.
B. Remove the two (2) upper Bedrail bolts per side.
C. Remove the three (3) upper Bulkhead bolts.
Step 2: Installing Mounting Flanges on Bedrails and Bulkhead
Note: Notice that two sizes of metric bolts have been provided. The four (4) large 8mm x 40mm bolts are to be used in the forward positions of the Track Mounting Flanges where the tiedown brackets were removed. The seven (7) smaller 6mm x 40mm bolts are to be used in all the other locations.
(more…)
[Read more →]
STEP 1. Remove the contents from the box and check for any damage. Verify all parts against the parts list.
STEP 2. Read and understand instructions completely before beginning installation.
STEP 3. Bolt mount brackets to vehicle body mounts using metric bolts provided in parts kit. See figure 1.
STEP 4. Position step bar up to the mount brackets and fasten with the 1/2” bolts and washers provided in the parts kit. Secure rear leg of step bar to correct hole location for your vehicle. Tube should not touch vehicle body. See figure 1.
STEP 5. Check to be sure Step Bar is properly aligned with vehicle. Tighten and torque all mounting bracket bolts to 55 FT. LBS.
(more…)
[Read more →]
