Automotive Manual PDF

The KraftWerks Honda Fit Injector Upgrade kit is designed to be used in conjunction with the KraftWerks Fit Base Supercharger Systems. If you are a competent mechanic with a good set of tools, the installation will be relatively simple. This is a general installation guide for the KraftWerks Fit Injector Upgrade kit; however each installation may vary slightly. Please keep these key factors in mind before installing:
Please review the entire installation guide before attempting install. If you have any questions about your ability to perform this installation, we recommend you take your vehicle to a performance shop for installation.
(more…)

[Read more →]

This transbrake has been thoroughly tested before being packed and shipped. Proper operation depends on following a few basic instructions. As you may know, the AODE/4R70W transmissions are computer controlled and must retain all wiring connections inside and outside the transmission. The following photos will help with the installation and operation of this transbrake.
(more…)

[Read more →]

Here we are installing Ford Racing C-Springs on an 04 Mustang GT. I’ll be using a 2-post lift for easy explanations and visual clarity, but the same procedure goes for those using a jack and jack stands. Remember, after installation, it is important to get a front wheel alignment. Camber/Caster plates may not be necessary when installing FRPP C-Springs.
(more…)

[Read more →]

Edelbrock Pro-Flo header components are designed to improve the exhaust efficiency of the Acura 1.8L engine. A performance gain can be expected with the installation of the system. This system requires no welding fo installation and retains all stock emissions equipment. Suggested tools needed for installation: This vehicle has some metric fasteners.
(more…)

[Read more →]