Automotive Manual PDF

Pump mounting
We have found the best location if using a tank in the bed is in this location. Drill 4 holes
Remove Intake
On LMM LBZ
Loosen all bolts and nuts labeled with red arrows
On LLY
Loosen 6, 12mm bolts/nuts on the intake manifold. Remove the intake manifold. (Note: it will not be easy to get at all the bolts and remove the manifold, but it can be done just moving the cables out of the way) Be careful not to lose the 2 EGR gaskets and 1 intake manifold gasket.
(more…)

[Read more →]

What’s included with your package:
• One HyperBoost diverter valve
• Two medium sized hose clamps
• One small hose clamp
• One instruction sheet (you are reading it)

Tools required for your installation:
• A medium sized flat-blade screwdriver
• Tin snips
• Regular or needle nose pliers
• A bit of motor oil or vegetable oil
(more…)

[Read more →]

This document explains injector removal, nozzle swap, and injector reinstallation on a VW TDI. The car used was a 2001 Golf (ALH engine). The instructions should be similar for earlier TDI engines (AHU and 1Z). I welcome email with comments or questions about the content of this howto!
(more…)

[Read more →]