Automotive Manual PDF

Step I:
Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground using a floor jack and jack stands or a (2) two post lift if available.
First, remove driver side front wheel, then unbolt upper shock mounting nut.(A) Next remove lower shock mounting nut and bolt.(B) Remove shock. Install shock stem spacer provided and reinstall bushings and shock.(C) & (D) Verify that all fasteners have been tightened to the proper torque specs and reinstall wheel.
*Be sure to torque the lug nuts to the proper OEM settings.
(more…)

[Read more →]

Step 1: Applies to H3 ONLY, for Colorado/Canyon please skip to step 2.
Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground using a floor jack and jack stands or a (2) two post lift if available.
First, remove driver’s side front wheel, then unbolt upper shock mounting nut. (A)
Next remove lower shock mounting nut and bolt. (B)
Remove shock. Install shock stem spacer provided and reinstall bushings and shock.
Verify that all fasteners have been tightened to the proper torque specs and re-install wheel.
*Be sure to torque the lug nuts to the proper OEM settings.
(more…)

[Read more →]

STEP I ASSEMBLY INSTRUCTIONS – Fuel Pump / Carburetor / Manifold
A) Install fuel pump on carburetor, using shortest fuel line hose (1 ū” long) and two small diameter clamps. Ensure that you connect the correct nipple from the fuel pump to the carburetor. (Refer to Fig. 3)
B) Install carburetor and fuel pump assembly on the intake manifold, along with gaskets, insulation block, lock washers and nuts supplied in kit. (Refer to Fig. 2) Tighten nuts to 8 – 12 foot lbs. torque.
C) Attach one end of 7″ fuel line to the pulse tube on the intake manifold. Slide two small diameter clamps over the fuel line and then attach the other end of the line to the crankcase fitting on fuel pump. (Refer to Fig 3.) Position clamps at each end of hose and tighten securely. Proceed to STEP II.
(more…)

[Read more →]

Install
Windshield:
Please check all components in Figures 1 and 2 before assembly.
Align windshield tabs with three holes in Mustang hood and place windshield in position.
Secure windshield by placing three lock washers on windshield tabs on underside of hood
(more…)

[Read more →]

1. Remove negative battery cable, then positive battery cable from the battery. If equipped, the Supplemental Restraint System will be deactivated when the battery is disconnected.
SteeRIng extenSIon
2. Remove the nut and bolt holding the steering column to the steering shaft located in the engine compartment about 8 inches down from the firewall. Mark the two shafts for realignment.
(more…)

[Read more →]