Automotive Manual PDF

Adapter Installation Location:
The HONASX connects to the 14-pin connector on the back of the factory head unit.
Compatible Radios:
The HONASX is compatible with ‘03-’06 Honda CD changer control head units with 14 pin connector. Note: As vehicle manufacturers continually introduce updated radio models there may be instances where the interface is not compatible. Please contact Technical support if you experience any problems. Have all radio model numbers, vehicle information and symptoms ready when you call.
(more…)

[Read more →]

Please test install this undertail BEFORE painting it. Even though we’ve tested our parts on designated bike models, it still may need slight modification to fit properly with other aftermarket parts.
Installation:
We highly recommend having a professional install this undertail. A dremel tool or similar is what we found the best to cut plastics.
1) Place bike on a rear wheel center stand.
2) Remove passenger seat and hardware which secure stock undertail section
(more…)

[Read more →]

“SECURE IDLE” is an ignition switch bypass device designed to provide all the electrical functions that the OEM ignition switch normally provides. For proper operation and long term performance, do not deviate from the wire connection instruction. For each wire connection, remove approximately one half inch of insulation from the OEM wire, but DO NOT cut the wire into. Cutting the wires causes high resistance and a possible failure point. Strip app. one half inch of insulation from the end of the “SECURE IDLE” wires to be attached to the OEM wires. Wrap the “SECURE IDLE” wire around the bare area of the OEM wire and solder the connection. Tape the connection thoroughly after it cools.
(more…)

[Read more →]

primary harness (H1) wire connection guide
primary harness (H1) wiring diagram
The primary harness supplied with this unit is the standard 12-pin harness used. Two wires in the plug are not used. The upgrade from this unit to a security system would simply require unplugging and exchanging control units and connecting the necessary wires to the vehicle. The functions of all the wires that are used in the primary harness are outlined in the following wiring diagram and the wire connections are described in the wire connection guides
(more…)

[Read more →]