This product is to be used ONLY on the Honda S2000 and is intended to provide increased driver support when using the stock lap belt and shoulder harness. It is NOT to be used as a replacement for competition belts or at any event where 4 or 5-point restraint systems are required. This product uses an electro-magnet to activate the factory inertia-sensing mechanism built into the seat belt assembly. It does not alter the factory restraint system in any way and has no effect on the seat belt retractors or air bag system. It simply activates the “tilt” mechanism built into the seat belt, the one that normally kicks in only when you corner or brake very hard. Modifry’s Seat Belt Lock is relatively easy to install and can be quickly removed, leaving no trace it was there.
(more…)
Honda S2000 Seat Belt Lock Installation
November 3rd, 2009 · No Comments
HONDA 750 AERO Thunder Air Filter Kit Installation Instructions
November 1st, 2009 · No Comments
Congratulations on your purchase of the HONDA 750 AERO Thunder Air Filter Kit. We’re sure you’ll be pleased with the new level of performance you’ll experience. This kit should only be installed on bikes that have been jetted (jet kit not included). We recommend that an experienced mechanic perform this conversion. Use the appropriate Honda service manual for reference to complete jetting of carbs. Remember, gasoline is extremely flammable and can be explosive under certain conditions. Work in a well-ventilated area and clean up any spills immediately. Check for leaks before riding.
(more…)
04-05 Honda CBR 600 F4i Fiberglass F13 Installation Guide
October 29th, 2009 · No Comments
Please test install this undertail BEFORE painting it. Even though we’ve tested our parts on designated bike models, it still may need slight modification to fit properly with other aftermarket parts.
Installation:
We highly recommend having a professional install this undertail. A dremel tool or similar is what we found the best to cut plastics.
1) Place bike on a rear wheel center stand.
2) Remove passenger seat and hardware which secure stock undertail section
(more…)
Acura RSX Seat Heater Install
November 14th, 2008 · No Comments
Be sure to test the heaters to make sure they work properly before going to the trouble of installing them. I just connected them to my battery terminals to do a quick test. This should only take a couple minutes and is a worthwhile precaution. Additionally, I would recommend getting some upholstery hog rings and hog pliers. These can be purchased as a package from JCWhitney for about $4-5.
(more…)
Suzuki Swift S Manual (Road Test)
April 27th, 2008 · No Comments
The original Suzuki Swift was launched in Australia in 1984, and with a zippy 1.3 litre engine, good build quality and attractive pricing, soon became a favourite with consumers. Owners that have kept Swift’s long term have also been rewarded with class leading reliability, and there plenty of originals still on the road today. The new model was previewed at the Sydney Motor Show, in 2004 and released in February 2005. Developed in Europe, Suzuki believe the new Swift will have wide international appeal., it’s available as a five door in Australia, with a 1.5 litre engine with a choice of either manual or automatic transmission It replaces the Suzuki Ignis in the Suzuki model line up.
(more…)