Automotive Manual PDF

First remove the plastic radiator cover on the front of the engine compartment using a flathead screwdriver and a pry tool. Use a screwdriver to pry the center nail of the push fastener upward about half an inch. The pry tool will then be used to fully remove these four panel pins and free the plastic panel from the body.

Next remove the air temperature sensor from the stock air tube, being careful not to harm the sensor. Set the sensor aside at this time, it will be re-used later.
(more…)

[Read more →]

Step 1. Radiatorshroud removal
-Remove the plastic radiator shroud by removing the two plastic rivets with a flat blade screw driver or pry tool. To do this you must first unlock the rivet by prying up on the head of the rivet, located at the center (the head will raise about a half an inch).
-Once the rivet has been unlocked it can then be removed.
-There are two christmas tree style fasteners at each edge of the plastic shroud. These are removed by inserting your flat blade screw driver/pry tool near the fastener and gently prying upward.
(more…)

[Read more →]