Automotive Manual PDF

Wheel spacers can provide extra clearance to the outer face of the caliper. This will also space out the entire wheel, widening the track width of the vehicle. Fender clearances should be checked on lowered cars, and longer lug studs or wheel bolts are usually required. Note: The Wheel Industry Council has issued guidelines advising wheel spacers not be used. It is the responsibility of the customer to insure wheel spacers are properly specified and installed.
(more…)

[Read more →]

1. Disconnect Battery. Do not skip this step. Also, do not try to “test” the LED array by connecting the leads directly to your battery. Permanent damage will occur to the LED array if you fail to heed these steps. Handle the LED array by the stainless steel bracket, not by the LEDs or the supporting circuitry.
2. Remove taillight lens and gasket.
3. Remove taillight bulb.
4. Remove the bulb connector from the back side of the taillight. Cut the two wires close to this connector.
5. Install the provided wire guide into the bulb hole.
6. Route the supplied electrical harness through wire guide to the area where connections will be made. Note that the ground connection (green wire) is made through the LED array’s stainless steel bracket.
(more…)

[Read more →]

1. Disconnect Battery. Do not skip this step. Also, do not try to “test” the LED array by connecting the leads directly to your battery. Permanent damage will occur to the LED array if you fail to heed these steps.
2. Remove taillight lens and bezel.
3. Remove light bulb and light bulb holder.
4. Remove the LED array from the stainless steel bracket.
5. Route the supplied electrical harness through the taillight and to the area where connections will be made.
(more…)

[Read more →]