Automotive Manual PDF

NOTE: Read all instructions before starting any work.
1. Remove the O.E. front pipe/muffler/tail pipe assembly from the vehicle. Lubricate the rubber isolators with WD-40, or a similar lubricant, to aid in removing the rod hangers. The O.E. system will not come off in one piece. Cut the system between the rear axle and the muffler. Both pieces will then come off easily.
2. Install DynoMax front intermediate pipe 54374. Insert the rod hanger into the rubber isolator on the RH frame. Finger tighten the nuts on the inlet flange connection to the converter pipe.
(more…)

[Read more →]

Tools Needed: 10, 12, 14 sockets and wrenches. You will also need a Oxygen Sensor removal tool or 22mm wrench or socket to remove the stock Oxygen sensors from the catalytic converter and install them in the new Jackson Racing header. Most of these tools are available at your local hardware or auto parts store.

IF YOU ARE NOT A COMPETENT MECHANIC, DO NOT ATTEMPT THIS INSTALLATION! ALLOW AT LEAST ONE HOUR FOR THE EXHAUST SYSTEM TO COOLBEFORE DOING ANY EXHAUST SYSTEM INSTALLATION WORK.
READ THESE INSTRUCTIONS THOROUGHLY! Follow the instruction STEP-BY-STEP, and your installation will be trouble free. If in doubt, CALL!
(more…)

[Read more →]

You have purchased the finest exhaust system available on the market today! Your Hard-Krome exhaust system has been carefully designed and tested in the dyno room and on the road to ensure the best performance possible for your motorcycle. ALL Hard-Krome exhaust systems feature our exclusive, patented Double wall Technology Construction that makes your pipes look as beautiful as the day you purchased them. Because of this technology, you can ride mile after mile without ever worrying about your pipes discoloring or turning blue. These instructions have been carefully prepared to ensure proper installation of your new Hard-Krome exhaust system. Following all the steps listed will ensure correctfit and performance as intended.
(more…)

[Read more →]

Take care when removing all mechanical fasteners - including nuts, bolts, washers, clips or pins - that secure or support your motorcycle’s stock exhaust system. Replace all damaged, twisted, cross-threaded, corroded or broken fasteners, clips or supports prior to installing this Hard-Krome exhaust system on your motorcycle.
(more…)

[Read more →]

Prior to installation, be sure your vehicle is parked on a level surface, and the exhaust system is cool. For safety purposes and ease of installation, we urge you to take your vehicle to a qualified service center or muffler installer that employs the use of a lift.

Exhaust System Removal:
1. Measure the exhaust pipe 7-1/2 inches forward of the rear axle and mark a line.
2. Using a saw or chain style pipe cutter, cut the stock system.
3. Using a 15 mm socket remove the two flange nuts.
4. Remove the front hanger from the rubber isolator and remove the front section of the stock exhaust system.
5. Remove the rubber isolator after the axle from both the vehicle and the exhaust system (See Fig. D).
(more…)

[Read more →]