Installation requires a professional mechanic. Prior to beginning, inspect the vehicles steering, driveline, and brake systems, paying close attention to the suspension link arms and bushings, anti-sway bars and bushings, tie rod ends, pitman arm, ball joints and wheel bearings. Also check the steering sector-to-frame and all suspension-to-frame attaching points for stress cracks. The overall vehicle must be in excellent working condition; repair or replace all worn parts. Read instructions several times before starting. Be sure you have all needed parts and know where they install. Read each step completely as you go.
(more…)
Superlift Steel Skid Plate 2001-05 Hummer H2 Installation Guide
September 2nd, 2008 · No Comments
Ford F-100/F-150 & Bronco Front Box Kit Installation Instructions
July 27th, 2008 · No Comments
FRonT SySTem InSTALLATIon
1. Park vehicle on clean, flat, and level surface. Block the rear wheels for safety.
2. Lift front of vehicle with hydraulic jack. Secure frame rails with jack stands. If installing optional long radius arms, make sure there will be clearance for brackets.
3. Remove wheels
4. Disconnect the anti-sway bar (if equipped) from the frame, retain hardware. (Fig 1)
5. Disconnect steering linkage from pitman arm, retain nut. (Fig 2)
(more…)
1987-1995 Jeep YJ 4.5” Suspension System
July 21st, 2008 · No Comments
This kit includes new braided stainless steel brake lines. Installation of these lines requires the entire brake system to be bled following the completed installation and prior to operating the vehicle. Consult your owner’s manual for the proper brake fluid to use for your vehicle. Fluid is not included in this kit.
(more…)
