Automotive Manual PDF

Time and Ease: Medium difficulty ­ 1­2 hours Tools/Supplies: Wire cutters/strippers, small rotary tool (Dremel), screwdriver, 10 or 15 amp inline fuse, 12v marine outlet with extra wire (Walmart), end connectors that will fit around your battery terminals
Step 1 ­ Open your glove box and locate the dimple or hole in the middle, where the outlet is already on the Forza version. (see photo section) Step 2 ­ If there is a hole already, try fitting the outlet in it. Doesn’t fit or no hole? Try grinding out some of the plastic with a Dremel or rotary tool. BE CAREFUL! You don’t want to grind out too much.
(more…)

[Read more →]

The following steps need to be performed from underneath the vehicle:
• Remove the three 7 mm screws holding the front fascia inside the radiator opening.
• Next, remove the 7 mm screws on either side (one on each side). These are the screws holding the bottom of the bumper cover - see picture.
(more…)

[Read more →]

Installation should take less than one hour with the proper tools. Before installation, set the parking brake and open the hood of the car. If car has been used recently, make sure engine has had time to cool before beginning to disassemble stock air intake. Please note that the hood was removed from the vehicle used for taking some of these pictures of the installation process. Some pictures show the hood supports disconnected from the hood. The hood does NOT need to be removed to install the LPE air intake and the hood support rods do NOT need to be removed either.
(more…)

[Read more →]

Installation instructions for the Lingenfelter Performance Engineering (LPE) air intake system for LT1 V-8 equipped 1993 Camaros and Firebirds (#LN0040), 50 state emissions legal (E.O. D-333-15):
Included in the LPE intake system:
• LPE plastic air intake
• K&Nfilter
• plastic block-off plate
• three plastic fasteners
• 3M Dual Lock hook and loop tape (used for Firebird installations only)
(more…)

[Read more →]

1. Remove the negative battery cable first, then the positive battery cable. If equipped, the Supplemental Restraint System will be deactivated when the battery is disconnected.
2. Measure and record the space between the bumpers and the body as well as the space between the cab and bed for reference during installation of this kit.
(more…)

[Read more →]