Automotive Manual PDF

INSTALLATION NOTE:
• Make sure the vehicle and the nose mask are clean and completely dry before installation. If moisture under the mask is allowed to dry, it may cloud the paint. If the mask gets wet, remove it and allow it to air-dry completely.
• Make sure any repainted surfaces are cured.
• Make sure the hood and nose of the vehicle have been waxed with a high-quality paste wax.
• Make sure you install the nose mask securely. If the nose mask starts to flap, or comes loose while driving, safely pull off the highway, stop the vehicle, and secure or remove the mask.
(more…)

[Read more →]

STEP 1. Remove the contents from box and check for damage. Verify all parts are present. Read instructions completely before beginning
STEP 2. Determine passenger and driver uprights and center section assembly and assemble as shown. Hand tighten all fasteners centered in slots or holes. Be sure dimple in ring mount plate is to the top.
STEP 3. For easier installation, it may be necessary to remove grille from vehicle but it’s not necessary on all models. Remove plastic shroud to gain access to grille by removing seven plastic pin retainers. Pull center pin up with a small flat tip screwdriver. Remove 6mm bolt from top of grille. Pull on outer edge of grille by applying firm pressure away from the fender, repeat on the opposite side and center section. Carefully remove grille from vehicle.
(more…)

[Read more →]