Prepare for the installation.
• If possible, install the SWI-ALP while you are installing the new head unit. Keep in mind you may need to plug in the factory stereo to locate certain wires; therefore do not complete the head unit installation until the SWI-ALP is working properly.
• Plan a general installation location for both the SWI-ALP plug and the control body. Keep in mind that the supplied wire harness is two feet long, and the 1/8″ plug harness is three feet long.
• Use a multimeter or approved measuring device for checking vehicle circuits
(more…)
SWI-ALP Universal Steering Wheel Control Interface Instructions
November 27th, 2009 · No Comments
RS900ERII/RS901II Series II Remote Engine Starting System Installation Instructions
December 28th, 2008 · No Comments
PROGRAM/OVERRIDE SWITCH: 2 PIN PLUG
This switch is used primarily for programming features of the RS900/901. However, if the Anti-Grind/Starter disable feature is installed, you MUST INSTALL this switch. This switch will allow the user to override the starter disable in the event of a non-operating remote control.
(more…)
Sniper X1 Vehicle Security System Installation Manual
December 4th, 2008 · No Comments
With the alarm disarmed, switch the ignition ON. Within 10 seconds press the valet switch 6 times, after 2 seconds, the siren will chirp for 2 seconds and then the system enters into the code learning mode. Within another 10 seconds, press any button of the first transmitter, the siren will chirp for 1 seconds and lights flash twice to confirm the code has been learned. Apply the same procedure within next 10 seconds for the second transmitter. The system will leave the code learning mode after finishing learning the code for 2 transmitters. If two transmitters are not programmed, the ignition is switched OFF or the time exceeds the 10-second programming time, the system will leave the code learning mode.
(more…)
