Fuelpak maps for the LTR450 were created with a White Brothers Power Pro performance module installed. The included Power Pro unit must be used in conjunction with the Fuelpak for proper function. Failure to do so will result in poor performance and may cause engine damage.
(more…)
Suzuki LTR 450 Fuelpak Fuel Management System
October 9th, 2008 · No Comments
2006-2008 Chevrolet Z06 Corvette High Flow Air Intake System
September 24th, 2008 · No Comments
This air intake kit requires re-calibration of the factory engine management software. If you do not have a way to re-calibrate the engine control module (ECM), do not install this system until you are able to do so.
• Disconnect battery ground.
• Remove gray retaining clip on the bottom side of the MAF sensor, then disconnect MAF sensor connector.
• Disconnect breather tube from bellows.
(more…)
C6 Corvette SCIC airbox Magnuson Supercharged Applications installation instructions
September 18th, 2008 · No Comments
Disconnect electrical connector for under hood light & unclip electrical connector for under hood light from the radiator shroud. Disconnect the electrical connector from outside air temp sensor located low on the right side of the shroud. Remove the 2 “christmas tree” push fasteners holding the radiator shroud to the condenser. They are located approximately midway up along each side. Raise front of vehicle, follow manufacturer instructions. Use jack stands to support vehicle.
(more…)
