Automotive Manual PDF

Your new Daystar body lift kit will allow the installation of 35” tires. Larger tires can be fitted if paired with our 2” torsion bar key kit, and some trimming . The tools needed for installation are on the last page . A list of parts in the kit are under the BOM, verify that you have all parts prior to installing your new Body Lift Kit . Make sure you have all of the proper tools and understand these directions before proceeding. Place Vehicle on level ground. Be sure that the wheels are blocked and the vehicle is in park.
(more…)

[Read more →]

Installation Instructions. Read Me!
I. DISCONNECT NEGATIVE (-) BATTERY CABLE
II. Remove Factory Intake Assembly
a) Loosen the factory hose clamps on each end of the factory intake tube assembly.
b) Using a flat head screwdriver, gently pry the radiator hose bracket from the factory intake tube assembly and remove from vehicle.
(more…)

[Read more →]

Installation Instructions:
1. Disconnect negative battery cable. Then loosen all three factory hose clamps located at the Mass Air Flow (MAF) meter and both factory intake tube.
2. Remove black cover on throttle body by pulling up and sliding towards front of truck. It is held by two grommets. Gently pry the radiator hose bracket from the factory intake tube assembly and remove the tube from the vehicle. A flat head screwdriver may be used.
3. Remove the factory air filter base and lid as an assembly. There are no bolts, just friction mounts, so just pull straight up on the air filter base to remove. Then remove the plate that held the base and lid. There are (5) 10mm bolts to unscrew to remove the plate. After everything is removed it should look like the picture above.
(more…)

[Read more →]

INSTALLATION:
1. Switch vehicle ignition to the off position.
2. Loosen the stock rubber grommet hose clamp that connects the stock intake tube to the throttle body. Pry loose the radiator hose retaining clip with a flat head screwdriver next to the fan shroud. Detach the stock intake tube along with the rubber grommet from the throttle body.
3. On the other end, loosen the hose clamp that connects the stock air duct to the mass flow sensor. Pull and remove the stock air duct from the mass flow sensor and away from the engine compartment.
(more…)

[Read more →]

BEFORE INSTALLATION OF CONVERTER TO TRANSMISSION
1. If transmission is not fresh, drain all old oil, clean the pan and replace the filter or clean screen.
2. Thoroughly flush oil cooler lines and cooler with clean varsol or other suitable solvent. Repeat process alternately in both lines until clean then blow air through the system. If any restriction is noticed in the lines or cooler, they must be replaced. If there are any twists or kinks in the lines restricting oil flow, the lines must be replaced.
(more…)

[Read more →]

Disassemble
1. Remove Front Under Panel by removing the seven 8mm hex screws
2. Remove Front bumper. On 11/01 and up models remove the four 8mm hex screws from under the car and one 8mm hex screw in the left and right fender well. Once screws are removed, (six in total) Grab bumper from each side and with a strong quick pull, the bumper should pop off. Disconnect the Fog lights and electrical connector. On 2001 models up to 10/01 there are two large reverse torx bolts that need to be removed from the bottom as well as the 6 8mm screws and then bumper will slide off. It is not necessary to pop it off
(more…)

[Read more →]