Automotive Manual PDF

This air intake kit requires re-calibration of the factory engine management software. If you do not have a way to re-calibrate the engine control module (ECM), do not install this system until you are able to do so.
• Disconnect battery ground.
• Remove gray retaining clip on the bottom side of the MAF sensor, then disconnect MAF sensor connector.
• Disconnect breather tube from bellows.
(more…)

[Read more →]

The following steps need to be performed from underneath the vehicle:
• Remove the three 7 mm screws holding the front fascia inside the radiator opening.
• Next, remove the 7 mm screws on either side (one on each side). These are the screws holding the bottom of the bumper cover - see picture.
(more…)

[Read more →]

Step 1. Radiatorshroud removal
-Remove the plastic radiator shroud by removing the two plastic rivets with a flat blade screw driver or pry tool. To do this you must first unlock the rivet by prying up on the head of the rivet, located at the center (the head will raise about a half an inch).
-Once the rivet has been unlocked it can then be removed.
-There are two christmas tree style fasteners at each edge of the plastic shroud. These are removed by inserting your flat blade screw driver/pry tool near the fastener and gently prying upward.
(more…)

[Read more →]

Disconnect electrical connector for under hood light & unclip electrical connector for under hood light from the radiator shroud. Disconnect the electrical connector from outside air temp sensor located low on the right side of the shroud. Remove the 2 “christmas tree” push fasteners holding the radiator shroud to the condenser. They are located approximately midway up along each side. Raise front of vehicle, follow manufacturer instructions. Use jack stands to support vehicle.
(more…)

[Read more →]

Instructions:
• Read instructions completely before beginning installation.
• Installation should take less than one hour with the proper tools.
• As you remove the stock components, pay careful attention to how things were attached or located. In many cases, the components will be reinstalled in the same way as they were removed.
(more…)

[Read more →]

Installation instructions for the Lingenfelter Performance Engineering (LPE) air intake system for LT1 V-8 equipped 1993 Camaros and Firebirds (#LN0040), 50 state emissions legal (E.O. D-333-15):
Included in the LPE intake system:
• LPE plastic air intake
• K&Nfilter
• plastic block-off plate
• three plastic fasteners
• 3M Dual Lock hook and loop tape (used for Firebird installations only)
(more…)

[Read more →]