Thank you for purchasing the Comptech Icebox Cold Air Intake for the 2002–2003 Honda Civic-Si and 2001 – 2003 Acura RSX. All components have been designed and manufactured utilizing the latest in technology and materials. Comptech recommends that you read through these instructions before starting installation and that you use an Acura Factory Shop Manual to supplement these instructions. All Comptech products are intended to be installed by a professional installer. Always use jackstands to support the vehicle when a car lift is not available. Always work in a clean environment and use the appropriate safety equipment to avoid any potential damage or injuries.
(more…)
Honda Civic Si & Acura RSX Icebox Cold Air Intake Installation Instructions
November 13th, 2008 · No Comments
Extended Remote Range VW TSB
August 7th, 2008 · No Comments
Radio frequency remote control functions only at close range. May be caused by missing radio frequency remote control antenna wire on vehicles up to and including VIN: 3VWRC29M0XM043029.
Service
If radio frequency remote control antenna wire is not installed. Install antenna wire Part No:
(more…)
OP-COM IMMOBILISER-II Manual Guide
April 27th, 2008 · No Comments
From 1995 and onwards, Opel / Vauxhall vehicles are factory installed with an immobiliser. The Immobiliser-I system can be found in Astra-F, Corsa-B, Omega-B, Vectra-B. The Immobiliser-II system can be found in Astra-G, Corsa-C, Omega-B, Vectra-B, Zafira, Meriva
(more…)
1994 Volkswagen Corrado SLC Repair Manual pdf
April 9th, 2008 · No Comments
1994 Volkswagen Corrado SLC 2.8L VR6 Radio/cassette or radio/CD player is equipped with an anti-theft protection circuit. Whenever battery is disconnected, radio will go into anti-theft mode. When battery is reconnected, radio will display CODE, and will be inoperative until proper code number is entered. Obtain security code before disconnecting battery. For reassembly reference, label all electrical connectors,vacuum hoses and fuel lines before removal. Also place mating marks on other major assemblies before removal. FUEL PRESSURE RELEASE Remove fuel pump relay (lower right relay located in fuse/relay panel). start engine and let idle until it stalls. Crank engine for an additional 5 seconds. Reinstall fuel pump relay.
(more…)
