1. Place floor jack under the outer ends of both axle halves and evenly raise the vehicle approximately one foot. Place floor jacks under the frame rails approximately 4″ behind the radius arm brackets. Ease the vehicle down on to the stands. Continue to lower the vehicle until there is little pressure on the coil springs.
2. Remove the tires.
3. If replacement shocks will be installed, then remove the existing shocks. If the existing shocks are to be reused, then only unbolt the bottom of the shocks.
(more…)
Coil Spring Installation Instructions
July 29th, 2008 · No Comments
Ford F-100/F-150 & Bronco Front Box Kit Installation Instructions
July 27th, 2008 · No Comments
FRonT SySTem InSTALLATIon
1. Park vehicle on clean, flat, and level surface. Block the rear wheels for safety.
2. Lift front of vehicle with hydraulic jack. Secure frame rails with jack stands. If installing optional long radius arms, make sure there will be clearance for brackets.
3. Remove wheels
4. Disconnect the anti-sway bar (if equipped) from the frame, retain hardware. (Fig 1)
5. Disconnect steering linkage from pitman arm, retain nut. (Fig 2)
(more…)
