Step 1
Remove the driver’s side hood cover by prying upward with both hands.
Step 2
Remove the driver’s side windshield molding. Do not peel off the rubber seal or separate from roof molding.
Step 3
Remove 4 screws from driver’s side roof railing. Remove roof and windshield molding and set it down on the table.
Step 4
Measure 1” from the beginning of the roof railing and mark on the masking tape the spot to drill ―” hole for your harness.
(more…)
Hummer H3 Delta 6X Light Bar Installation Instructions
January 9th, 2010 · No Comments
Specialty Tigertop Installation Instructions
October 14th, 2009 · No Comments
Install Front and Rear Aluminum Angles
Using the bolts from the factory hard top or those supplied in the kit, install the aluminum angle rails in the existing holes on the top of the body edge. Fasten the bolts with the 5/16″ Nuts and 5/16″ Washers from the parts kit. There should be a 3″ space between the two pieces on each side for the Bow Mounting Bracket. There will be an extra hole at either end of the rails. Drill a 3/16″ hole in the body at these locations and use the #14 x 1/2″ Sheet Metal Screws to secure the rails in place.
(more…)
