Automotive Manual PDF

1. Take the kit out of the box and lay everything out. You can install either the ballasts or bulbs first but typically it is easier to install the bulbs first.
2. Remove the access cap from the rear of your headlight housing as shown.
3. Drill a hole in the center of the cap as shown. If you use a hole saw that will be all you need. If you use the small drill bit you will need to use your dremel to cut a 1″ hole. You may want to use some sand paper just to smooth the edges you have cut.
(more…)

[Read more →]

1. Install the large o-ring on the threaded nipple on the bottom of the Filter Adapter.
2. Using a little diesel fuel, lubricate the filter gasket and thread the fuel filter onto the filter adapter by hand. Once the filter is on the adapter hand tight tighten the filter one additional complete turn, using a pair of strap wrenches. It is helpful to put a mark on the filter to know when you have complete one full turn.
(more…)

[Read more →]