Start off by removing the side cover over the fuse panel on the side of the dash. Then remove the 3 T20 torx screws under the dash for under-dash shelf. Now you can pull the left section of the dash panel that covers under the colume off. That will expose another T20 torx screw that holds the right side section to the knee bar, remove the screw and pull towards you to remove the panel. Now there are 2 T25 screws and 4 T20 screws that hold the black metal knee bar to the dash. remove all 6 screws and remove the knee bar. Now you can see the fuse panel and relay carrier clearly.
(more…)
Extending Range of Remote Antenna by Splicing Longer Wire
August 13th, 2008 · No Comments
Installation Instructions for FORD FOCUS
March 7th, 2008 · No Comments
Tools & Materials Needed: 1. Utility Knife 7. Crank Spring Removal Tool 2. Wire Crimper (Special Tool, available at most 3. Torx™ Wrenches Auto Parts Stores) – or – 4. Hex Nut Drivers 8. Flat Screw Drivers (2) 5. Drill and Bits 9. Add-A-Circuit™ fuse adapter 6. Phillips Head Screw Driver 10. Silicon Sealant (Clear or Black) A. Removing the Door Panel Coverings 1. For ease of installation, do both sides at the same time. 2. Roll the windows to approximately 1/2 open, and so the crank handle is in the Down Position. With either the Crank Spring Removal Tool, or a flat Screwdriver, remove the spring, located in a slot on the back of the crank.
(more…)
