Automotive Manual PDF

Read these instructions completely
Step 1:Take the ignition cover off. Are The Replacement Parts Similar? Compare the replacement part to the original. The replacement part should match, including the mounting hole locations. If not: Double check the application listing with your bike.
Step 2: Remove the flywheel using a proper puller. Remove the baseplate with the original stator. Disconnect the wires from the wiring loom.
Step 3: Remove existing stator coil off the baseplate and cut the wires close to the coil. Replace it with the new unit and feed the new leads though the holes in the baseplate.
(more…)

[Read more →]

Jack-it, Inc. strongly recommends this kit be installed by a professional mechanic. Installing this kit will not strengthen or reinforce the stock frame of the vehicle, nor will it increase rollover protection. This kit is designed to level the front end of the vehicle in relation to the height of the rear end. We strongly advise you to operate your vehicle responsibly at all times and that you periodically inspect all suspension and drive train components for tightness of fit or for any damage.
(more…)

[Read more →]

This workshop manual contains technical specification, descriptions and instructions for repairing the standard versions of the following engines MD11C, D, MD17C, D. The workshop manual displays the operations carried out on any of the engines above. As a result the illustrations and pictures in the manual that show certain parts on the engines, do not in some cases apply to all the engines listed above. However the repair and service operations described are the same in all essential details. Where they are not the same this is stated in the manual and where the difference is considerable the operations are described separately. Engine designations and numbers are given on the number plate (See page 9). The engine designation and number should be given in all correspondence about the engine.
(more…)

[Read more →]

Engine may be identified by using Vehicle Identification Number (VIN) stamped on a metal pad, located near lower left corner of windshield. The sixth and seventh character identifies engine model. Engine identification number, located on left side of cylinder block below cylinder head, may be required when ordering replacement parts.
(more…)

[Read more →]

Adjusting Booster Mode to Fit a Child Converting from Harness to Booster Use of a Locking Clip Replacement Parts Glossary Trouble Shooting Care and Maintenance Use and Installation of a Top Tether Welcome to the Recaro family of high quality automotive products and thank you for purchasing your new Recaro child restraint system. Recaro has had 100 years’ experience in the design and manufacture of premium automotive products. To make all the products Recaro makes worthy of the name, we’ve subjected them to a comprehensive product development program complying with American FMVSS 213 safety standards.
(more…)

[Read more →]

This manual lists parts for walk-in (Aeromaster®) van bodies built on Ford chassis covering Model Years 1996 and later. Because Utilimaster manufactures many customized vehicle bodies, this manual cannot list and illustrate every possible part in every vehicle. Nevertheless, the most common body options are described here, and Customer Service can help with other options not shown. It contains exploded-view drawings and parts lists to aid in ordering replacement parts.
(more…)

[Read more →]