This air intake kit requires re-calibration of the factory engine management software. If you do not have a way to re-calibrate the engine control module (ECM), do not install this system until you are able to do so.
• Disconnect battery ground.
• Remove gray retaining clip on the bottom side of the MAF sensor, then disconnect MAF sensor connector.
• Disconnect breather tube from bellows.
(more…)
2006-2008 Chevrolet Z06 Corvette High Flow Air Intake System
September 24th, 2008 · No Comments
Coil Spring Installation Instructions
July 29th, 2008 · No Comments
1. Place floor jack under the outer ends of both axle halves and evenly raise the vehicle approximately one foot. Place floor jacks under the frame rails approximately 4″ behind the radius arm brackets. Ease the vehicle down on to the stands. Continue to lower the vehicle until there is little pressure on the coil springs.
2. Remove the tires.
3. If replacement shocks will be installed, then remove the existing shocks. If the existing shocks are to be reused, then only unbolt the bottom of the shocks.
(more…)
