Before installing a big bore kit, you should first install a high volume oil pump. A high volume oil pump will deliver up to 300% more oil to your top end which will only help preserve the life of your engine. To install the big bore kit you will need to:
1. Stuff a CLEAN rag behind the piston to seal off the crankcase.
2. Install a c-clip into one side of the piston. When installing the c-clip, compress the c-clip just enough to get it into the piston. Note the position of the c-clip once it is installed.
(more…)
Big Bore Kit Install Instructions
November 24th, 2009 · No Comments
Short-throw Shifter Installation Guide Removal Procedure
September 16th, 2008 · No Comments
1) Remove the shift control knob.
A. Lift up on the rear portion of the shift control closeout boot retaining ring and detach the retaining ring from the console. Important Detaching the shift control knob from the shift lever may require a large amount of physical effort.
B. Firmly grasp the shift control knob and pull straight up to detach the shift control knob from the shift lever.
C. Remove the shift control closeout boot and knob assembly.
(more…)
Hummer H2 Spare Tire Cover Installation Instructions
August 6th, 2008 · No Comments
Thank you for the purchase of your new Hummer H2 spare tire cover. Please inspect your package contents before beginning installation. Included should be a molded faceplate and stainless steel retaining ring with locking mechanism. The stainless steel ring is covered with a protective vinyl cover that should not be removed until installation is completed.
(more…)
