For breaker points, the 5 ohm coils should be used or the 3 ohm coils can be used and a 1 to 2 ohm ballast resistor placed in the 12 volt line going to the coils. Generally, a ballast resistor should not be used with DYNA COILS on electronic ignitions. The secondary towers are designed to accept 7 or 8 mm automotive spark plug wire. Wire kits are available trom DYNATEK.
1) Remove the gas tank. Locate the two ignition coils.
2) Unplug the primary wires coming from the coils and disconnect the high voltage wires from the spark plugs. Remove the coil mounting bolts, and remove the coils.
(more…)
DYNA Ignition Coil Installation Instructions
November 17th, 2009 · No Comments
42Draft Designs VW M10×1 Oil Pressure Relocation Kit (42-004) Installation Instructions
December 3rd, 2008 · No Comments
1. Locate the oil filter flange on your motor and find the stock oil pressure sender. To access this location fully, certain emissions devices or the intake manifold may need to be removed. Remove the wiring harness from the stock oil pressure sender and move aside. Using a 24mm deep socket, unscrew the sender.
2. Install the included M10×1 adaptor in the stock oil pressure sender port. Start threads by hand and tighten snug using an open end wrench. Do not over tighten this adaptor! Install one end of the 12” extension hose and use an open end wrench to tighten.
(more…)
