Automotive Manual PDF

1. Attach the left strake to the side under spoiler using the three self-tapping screws.
2. Remove the three self-tapping screws that fasten the front inner fender to the fenderwell.
3. Remove the four clips that fasten the existing side under spoiler to the side sill, then remove the spoiler by sliding it toward the front.
4. Remove the spring nut from the end of the side under spoiler you just removed.
5. Remove the eight clips from the side sill by turning them 45 degrees.
(more…)

[Read more →]

This B&M Precision Sport Shifter has been designed to work on most 2002+ Acura RSX/Honda Integra (including 6- spd Type-S) and 2001+ Honda Civic models equipped with a manual transmission. It has been engineered to greatly reduce shift throw and improve shifter feel. Check the parts and tools lists at the beginning of these instructions for the supplied parts and the tools required to install your B&M Precision Sport Shifter. Installation of the B&M Precision Sport Shifter can be accomplished by anyone with minimal mechanical experience.
(more…)

[Read more →]

Wheel spacers can provide extra clearance to the outer face of the caliper. This will also space out the entire wheel, widening the track width of the vehicle. Fender clearances should be checked on lowered cars, and longer lug studs or wheel bolts are usually required. Note: The Wheel Industry Council has issued guidelines advising wheel spacers not be used. It is the responsibility of the customer to insure wheel spacers are properly specified and installed.
(more…)

[Read more →]

Be sure to test the heaters to make sure they work properly before going to the trouble of installing them. I just connected them to my battery terminals to do a quick test. This should only take a couple minutes and is a worthwhile precaution. Additionally, I would recommend getting some upholstery hog rings and hog pliers. These can be purchased as a package from JCWhitney for about $4-5.
(more…)

[Read more →]

1. Pull down chrome collar and carefully unscrew and remove the stock shift knob.
2. Remove the front console cover. Pull up from the front to unclip the clips and remove from the vehicle.
3. Remove the 2 screws securing the front part of the console. Remove any additional screws that may be holding the center part of the console in place, this may vary by year and model. Lift the 2 tabs shown to the right over the center section of the console so that they rest on the outside of the console assembly.
(more…)

[Read more →]

Kit Number 05126NOS is intended for 4 cylinder 2000-2005 Acura RSX applications. This kit was designed to be used on late model multi-point fuel injection type engines with 43 psi ± 5 psi fuel pressure.

NOTE: This nitrous oxide injection system injects a mixture of nitrous oxide and fuel into the air intake duct. If the instructions are not carefully followed, poor mixture distribution can occur resulting in variations of air-fuel ratio from cylinder to cylinder. In extreme cases intake manifold backfires can occur if the instructions are not followed exactly.
(more…)

[Read more →]