The rulers and templates will make it easier to measure stake pockets in tenths of an inch, just like in the metal shop. You will use these to accurately measure the dimensions of your stake pocket. Before cutting out and using the rulers and templates, make sure the rulers on this page are the correct size by comparing their length your own ruler. If the length is not correct, enlarge or decrease the size of the printout (using the print dialogue box in windows) make them the correct length. With my computer I had to increase the size of the printout by 104%. When the printed rulers are the correct length, the mount block templates will also be the correct sizes. Cut out the ruler at the right, including both the blank portion and the printed side.
(more…)
GeoTool Pickup Truck Antenna Mount Size Guide
August 2nd, 2008 · No Comments
2008+ Mitsubishi Lancer QuickLIFT Installation Guide
June 19th, 2008 · No Comments
Remove all items from the packing tube. You should have the following before beginning:
* (2) Gas springs (RT-QL-170-A6A) - Be sure to cycle them a few times before installing.
* (4) #2-3/16″ Multi-grip rivets (used on hood brackets)
* (2) ball-studs and washers each with a locking nut.
* (2) mounting brackets
* Printed Color Instructions
* Gas Spring locking clips - (Already installed in the gas spring ball-ends - Remove before assembly)
(more…)
