STEP 1. Remove the contents from the box and check for any damage. Verify all parts against the parts list. Read and understand instructions completely before beginning installation.
STEP 2. Measure, and mark clearly, from the front of pinch weld towards the rear of vehicle for bracket positions. Suggested locations at 14 1/2”,33 1/4”, 49 1/2” and 61 1/2”.
STEP 3. Drill 5/16” holes as marked on pinch weld. Drill each hole in pinch weld so they are centered vertically.
STEP 4. Under the vehicle near the first 2 hole locations you will see 2 black body plugs, remove these
(more…)
2001-02 Honda Passport Step Board Kit Installation Instructions
November 2nd, 2009 · No Comments
Toyota Tundra Double Cab 2007 AMP Installation Guide
August 31st, 2008 · No Comments
Remove parking brake cable support from frame. Seperate bracket and remove bracket from brake cable. Flip bracket 180 degrees to cable. Secure parking brake cable support to frame so that the bolt is now below the cable.
(more…)
HUMMER H2 2003 and newer AMP Installation Guide
August 7th, 2008 · No Comments
Due to vehicle-build variations the Power Step may not correctly align with vehicle cladding. Using supplied shims, please follow the instructions be- low to correct the alignment. Remove canister purge valve bracket from rock rail remove existing rock rail by unscrewing ten bolts Install new canister purge valve bracket on fourth set of holes from the front (upper bolt)
(more…)
