Automotive Manual PDF

Remove the contents from the box and check for any damage. Verify all parts against the parts list.
Read and understand instructions completely before beginning installation.
Remove 10mm bolts from bumper brace located on back side of front body mount if present. For each side, place Mount Bracket up to the backside of the body mount and secure using existing 10mm bolts removed in step 3. (On trucks without existing bolts, use the 10mm hardware provided in the bolt kit).
(more…)

[Read more →]

1. Assemble your motor/bracket assembly. Your actuators came with two Phillips head screws. Use these to secure your the actuator to the bracket.
2. Remove the door panel and 3 torque screws that hold the latch. For most GM vehicles, screw size is T30.
3.Using a pick or similar tool, un-snap the plastic retaining clip that holds the rod to the back of the inside handle. Be careful not to damage the rod; you will reuse it.
4. Remove the clip that holds the wiring to the door and push it through. This step is not required if your vehicle doesn’t have power door locks.
(more…)

[Read more →]