The machine can operate on any flat non resilient floor.Make sure that the machine rests solely on the three support points provided (Fig.2a). It is advisable to secure the system to the ground using the specific feet (Fig. 2a). if the machine is continually used with wheels weighing over 35 kg. The machine is supplied with a single-phase mains cable plus earth (ground). The power supply voltage (and mains frequency) is indicated on the machine identification plate and cannot be changed. Connection to the mains must always be made by expert personnel. The machine must not be set up without proper earthing.
Connection to the mains should be through a slow acting safety switch rated at 3 A (230V) or 8 A(115 V).
(more…)
Model 1260 Wheel Balancer Manual
February 14th, 2009 · No Comments
Model 1250 Wheel Balancer
January 19th, 2009 · No Comments
General safety recommendations
- The wheel balancing machine should only be used by duly authorized and trained personnel.
- The wheel balancing machine should not be used for purposes other than those described in the instruction manual.
- Under no way should the wheel balancing machine be modified except for those modifications made explicitly by the manufacturer.
(more…)
1995 Volvo 850 A/C-Heater System - Manual
December 9th, 2008 · No Comments
System is equipped with a cycling clutch system that uses an expansion valve in refrigerant line between condenser and evaporator, near condenser. System is engaged when A/C switch on control panel is pressed. See Fig. 1. Pressure switch on accumulator cycles compressor clutch on and off. Blower fan speed is controlled by sliding switch on lower left of A/C-heater control panel.
(more…)
