Automotive Manual PDF

All left / right descriptions are from the point of view of the rider when seated on the bike in the riding position.
Note: the condenser upgrade cable supplied will have a black cover to make it inconspicuous enough for a concours show bike. The example shown has a red cover to highlight the correct location and routing.
1. Place the bike on the center stand.
2. Remove the left side cover.
3. Loosen the rear engine mounting bolt. This is a long bolt that passes through both rear engine hangers. If mounted correctly, the nut, washer and lock washer should be on the right side of the bike. Yours may be reversed.
(more…)

[Read more →]

Dodge Charger Figure Grille Installation
Figure 1. Examples of low-profile Philips screwdrivers. 1) Ratchet (¼” drive) with ¼” socket and Philips bit. 2) Offset Philips screwdriver.
1.1) Remove radiator covers. Begin by popping the hood of your vehicle. There are two plastic protective shields which cover the radiator area. These are held in place by small clips which will let go easily by pulling on the pieces. Fig. 2 shows these covers and illustrates their removal.
(more…)

[Read more →]

DO NOT try to run the vehicle at full throttle at sea level altitude with a supercharger unless the fuel tank is filled with good 91-octane fuel. Failure to heed this warning can result in severe engine damage. Special Note: If you do not have a factory workshop manual, buy one now! It is good to have for any repairs now and in the future. The factory manual is available from Helm Publications, 800-782-4356. Tools Needed: 8, 10, 11 (7/16”), 12, 13 (1/2”), 14 (9/16”), 15, 17, sockets and wrenches, a 5mm Allen wrench, Phillips and straight blade screwdrivers, and a telescoping magnet.
(more…)

[Read more →]