Automotive Manual PDF

RSS Feed

The Resources for Automotive

Bulk Instructions Simple

December 5th, 2009 · No Comments

To get the most life and performance from RaceTEX bulk muffler packing, a mu ffler should be repacked with the core in it. Ideally, you would like to fill the front of the muffler first (the end closest to the engine) and work towards the exit. This isn’t always possible as with mufflers that have cores welded to the rear end-cap (Honda CRF150R, White Brothers E-Series for example).
(more…)

[Read more →]

1994–1996 Ford Econoline Intelligent Lift Interlock System (ILIS) - Installation Instructions

July 3rd, 2009 · No Comments

To aid in installation, first gain access to the connection points. Remove the lower dash panel below the steering column and the engine cover. Also, gain access to the lift power switch and the lift door switch circuits. These are usually accessible in the front control panel. It is not necessary to cut any Ford wires during the installation of the ILIS wire harness.
(more…)

[Read more →]

1993 Mazda X-5 Workshop Manual

August 8th, 2008 · No Comments

This workshop manual assumes that you have certain special tools that are necessary for the safe and efficient performance of service operations on Mazda vehicles and that you know how to use them properly. It also assumes that you are familiar with automobile systems and basic service and repair procedures. You should not attempt to use this manual unless these assumptions are correct and you understand the consequences described below.
(more…)

[Read more →]

Automatic Transa le Workshop Manual JA5A–EL

August 7th, 2008 · No Comments

This manual contains procedures for performing all required service operations. The procedures are divided into the following five basic operations:
— Removal/Installation
— Disassembly/Assembly
— Replacement
— Inspection
— Adjustment
(more…)

[Read more →]

Retrofit trailer hitch

July 6th, 2008 · No Comments

The body sealing compound and underbody sealant must be removed from all the body mounting points of the trailer coupling. The mounting points should then be cleaned with a commercially available cleaning agent. Apply anticorrosion paint to bare-metal areas of the body.
(more…)

[Read more →]

BMW Parts and Accessories - Installation Instruction Manual

March 21st, 2008 · No Comments

Towing hitch - electrical mounting parts for BMW 7 Series (E38) | bmw e38 fuse | Technical knowledge is required. Installation time approx. 4-5 hours, which can vary according to the condition and fittings of the vehicle. If the towing hitch has been retrofitted in the Feredal Republic Germany, final inspection is required at the Technical Inspecting Agency (TUV) in accordance with 19 (2) of the German appropriate entry in the car paper is necessary.
(more…)

[Read more →]