Automotive Manual PDF

SECTION 1: PRE-INSTALLATION PRECAUTIONS:
Step 1: Remove the negative battery cable. Before removing the battery cable, verify that you have the “anti theft” radio code. It is usually located in your owner’s manual. If you cannot find the radio code, take your car to your local Honda dealer so that they can retrieve the code through the Honda computer network.
Step 2: Jack your car up, or put the car up in the air if you are working in a shop. Support your car with Jack Stands or Ramps if you are working on the ground. Never work under a car without some type of reliable support.
(more…)

[Read more →]

INSTALLATION NOTE:
• Make sure the vehicle and the nose mask are clean and completely dry before installation. If moisture under the mask is allowed to dry, it may cloud the paint. If the mask gets wet, remove it and allow it to air-dry completely.
• Make sure any repainted surfaces are cured.
• Make sure the hood and nose of the vehicle have been waxed with a high-quality paste wax.
• Make sure you install the nose mask securely. If the nose mask starts to flap, or comes loose while driving, safely pull off the highway, stop the vehicle, and secure or remove the mask.
(more…)

[Read more →]

Step 1:
Locate the points along the pole where your car door would make contact (typically these points would be the door handle, the apex of the door, and down near the lower frame of the door). If two vehicles are parked side-by- side, you may want to take into consideration where the second vehicle door makes contact with the pole as well. This will offer the maximum product effectiveness and economy. Slight adjustment and arrangement will usually allow for mutually good ring location for both vehicles. However, in rare situations such as large variations in vehicle height (i.e. Corvette and Ford Excursion) it may be necessary to purchase additional bumper rings to properly protect the vehicles.
(more…)

[Read more →]

This mounting clamp will mount to your Grand Vitara’s roof rack using the supplied mounting hardware. The lightbars mounting foot will mount to the bracket. It is recommended that two people do the installation as you will need to adjust both sides of the brackets and feet once it is on the vehicle.
(more…)

[Read more →]