Automotive Manual PDF

1. Remove the OEM gas cap.
2. Remove the 3 mounting bolts from the filler neck.
3. Remove plastic gas shroud by turning counter clock wise and pulling up.
4. Attach the black latch using the 6-32 x 3/16 pan head screws provided.
(more…)

[Read more →]

STEP 1. Remove the contents from the box and check for any damage. Verify all parts against the parts list.
STEP 2. Read and understand instructions completely before beginning installation.
STEP 3. Determine Driver and Passenger Uprights and Top and Bottom Tubes. (Uprights are positioned so raised side of bolt holes are facing each other and the Tube with the two pierced holes is the Bottom Tube).
(more…)

[Read more →]

STEP 1. Remove the contents from box and check for damage. Verify all parts are present. Read instructions completely before beginning
STEP 2. Determine passenger and driver uprights and center section assembly and assemble as shown. Hand tighten all fasteners centered in slots or holes. Be sure dimple in ring mount plate is to the top.
STEP 3. For easier installation, it may be necessary to remove grille from vehicle but it’s not necessary on all models. Remove plastic shroud to gain access to grille by removing seven plastic pin retainers. Pull center pin up with a small flat tip screwdriver. Remove 6mm bolt from top of grille. Pull on outer edge of grille by applying firm pressure away from the fender, repeat on the opposite side and center section. Carefully remove grille from vehicle.
(more…)

[Read more →]

This wheel is a direct replacement for your original factory steering wheel with spoke mounted control switches. The original airbag (SIR) module, horn switch, switch harness, switches and shroud from the factory wheel must be removed and transferred to the new GRANT wheel.
(more…)

[Read more →]

Disassemble
1. Remove Front Under Panel by removing the seven 8mm hex screws
2. Remove Front bumper. On 11/01 and up models remove the four 8mm hex screws from under the car and one 8mm hex screw in the left and right fender well. Once screws are removed, (six in total) Grab bumper from each side and with a strong quick pull, the bumper should pop off. Disconnect the Fog lights and electrical connector. On 2001 models up to 10/01 there are two large reverse torx bolts that need to be removed from the bottom as well as the 6 8mm screws and then bumper will slide off. It is not necessary to pop it off
(more…)

[Read more →]

This guide INSTALLATION INSTRUCTIONS step:
1. Remove positive and negative battery cables. If equipped, the Supplemental Restraint System will be deactivated when the battery is disconnected.
FRONT BUMPER REMOvAl
2. Note location of front bumper in relation to the front of the vehicle for use in alignment during reinstallation.
3. Remove lower shroud located between the radiator and the front bumper. This provides access to the inside bumper bolts.
(more…)

[Read more →]