Automotive Manual PDF

Upon receipt of the Rocket Locker, the casting and the light should already be assembled and wires should be fed thru casting.
Step 1: Feed wires thru hole in the oval gasket.
Step 2: Install Allen head bolts through the hole in Rocket Locker casting, plastic oval gasket, and rubber expander.
Step 3: Install threaded back plate on Allen head bolt. Snugly tighten the back plate against the rubber expander.
Step 4: Remove the tail light lens. To do this, open tailgate and remove the screws that hold the lens in place (refer to picture below). If you are not sure which screws hold the lens in place refer to your owner’s manual on how to replace tail light bulbs. Then release the tabs on the other side of the lens.
(more…)

[Read more →]

If your truck does not have a locking tailgate (like provided on many full size Fords, Toyotas and Nissans), you will need to purchase an aftermarket tailgate lock (i.e., Pop’ N Lock, Bully Tailgate Lock, etc.,) to be able to lock the tailgate shut and to secure your truck bed. These lock sets basically replace your existing tailgate handle and convert it into the equivalent of a factory installed locking tailgate. Changing these tailgate lock handles is the equivalent of changing a “door knob” in that you simply loosen the 2 bolts on the inside of the tailgate, remove your non-locking tailgate handle, and replace with one that locks. These install really easily without any drilling and you can buy these at any truck accessories store. Once the cover is closed (and latched), you just simply lock the cover, then lock up your tailgate handle and you now have a really secure trunk!
(more…)

[Read more →]

Installation Notes:
• The T-Rac mounts onto the side rails of your truck without drilling.
• Installation is straight forward, and should take approximately 45 minutes to complete.
1. Verify that you have received the correct parts using the assembly drawing and packing list
2. Slide 6 T-bolts into slot under crossbar (3 per side) note: the flat recess must face down
3. Attach each crossbar onto a left and right corner unit by inserting the 2 T-bolts through the saddle plate holes, and attaching locknuts. Next fasten the corner brace to the crossbar with the remaining T-bolts, washers, leaving the 3/8” self-locking nuts loose for adjustments later. Attach the bottom of the corner brace (Dimple Side) using the 3/8-16 x 1-1/4” Hex head cap screw with the Washers (Figure 2) to the corner unit.
(more…)

[Read more →]

Ford Sport Tracs, because of their unique nature, require additional assembly procedures to install the side rails. A set of support brackets and hardware have been included with your TruXedo® kit in place of the clamp assemblies used on standard pickup boxes. These have been especially designed to fit your Sport Trac composite box.
(more…)

[Read more →]

Refer to owner’s manual to install your Ford SuperCrew TruXedo kit. Follow this instruction sheet to install TruXedo® side rails on your Ford SuperCrew. Read manual and these special instructions prior to installation of kit. Side rails are notched and pre-bent to conform to pickup bed.
(more…)

[Read more →]