Automotive Manual PDF

These instructions explain the procedure required to mount either the Windjammer IV or Vindicator II fairing to your motorcycle. We urge you to follow the preparation and assembly sequence from start to finish. This will benefit you directly in several ways:
1) You will be assured the fairing is properly installed and is immediately ready for operation.
2) You will minimize unnecessary confusion, moaning and scraped knuckles.
3) You will protect your investment by doing it right, and
4) With the confidence that nothing has been overlooked, you won’t have to waste time backtracking to correct mistakes. That’s time you could spend riding.
(more…)

[Read more →]

Parts included:
- main bracket, polished, chromed
- wide cateye taillight, w/ 36” long wires (if ordered)
- fasteners: (2) ž” x ―” bolts, nuts, (4) washers for main bracket
- (2) small washers for mounting taillight to main bracket

Rear fender assembly:
- remove seat – two bolts on side
- remove seat holding metal bracket (7,22)
- disconnect rear wiring harness from wiring cluster above battery; these include rear turn signal and rear brakelight wires
- remove 2 bolts on each side of rear fender strut (9,16); this will loosen the rear fender entirely
- lift off the rear fender assembly carefully, making sure not to scratch paint !
- remove seat nut (17), and carefully separate fender (12) from metal frame (13)
(more…)

[Read more →]

Please test install this undertail BEFORE painting it. Even though we’ve tested our parts on designated bike models, it still may need slight modification to fit properly with other aftermarket parts.
Installation:
We highly recommend having a professional install this undertail. A dremel tool or similar is what we found the best to cut plastics.
1) Place bike on a rear wheel center stand.
2) Remove passenger seat and hardware which secure stock undertail section
(more…)

[Read more →]

To avoid exceeding the maximum ratings in any condition, the voltages must be checked with no load at the power supply output.

Electrical Connections
Wiring Using the Screw Terminals
WARNING Make sure that you connect only de-energized wires.
(more…)

[Read more →]