Automotive Manual PDF

With the alarm disarmed, switch the ignition ON. Within 10 seconds press the valet switch 6 times, after 2 seconds, the siren will chirp for 2 seconds and then the system enters into the code learning mode. Within another 10 seconds, press any button of the first transmitter, the siren will chirp for 1 seconds and lights flash twice to confirm the code has been learned. Apply the same procedure within next 10 seconds for the second transmitter. The system will leave the code learning mode after finishing learning the code for 2 transmitters. If two transmitters are not programmed, the ignition is switched OFF or the time exceeds the 10-second programming time, the system will leave the code learning mode.
(more…)

[Read more →]

Keep wiring away from moving engine parts, exhaust pipes and high-tension cable. Tape wires that pass through holes on the firewall to prevent fraying. Watches out sharp edges that may damage wires and causes short circuit.
CAUTION: Do not connect the wire harness to the control module until all wiring to vehicle is complete.
(more…)

[Read more →]

The Suzuki CAT1 consists of the following main components;
• Installed CAT1 main unit
• 2 x remote transmitters
• Installed protecting switch
• Installed system fuse and spare fuse
• LED system indicator
(more…)

[Read more →]