Tools needed: 8mm open end wrench or socket 7/16 socket or open end wrench 1/4×1 bolts, 5/16 flat washers and nuts
1. Using the 8mm wrench, remove the factory Air Dam.
2. Position Air Dam aligning the center hole of Air Dam with the center hole of bumper.
3. Using a bolt with flat washer on the bolt, push bolt up through Air dam into bumper.
4. Install a flat washer, and a locking nut from above. DO NOT tighten at this time.
5. Install the balance of the bolts making sure that a flat washer is against the Air Dam.
6. Once all bolts are installed, tighten starting from the center of the Air Dam working right and then center of the Air Dam working left.
(more…)
97-98 Ford Air Dam 4×2 and 4×4 Installation Instructions
June 26th, 2009 · No Comments
SA314 Mounting Bracket 2003 Ford Expedition
April 14th, 2009 · No Comments
The siren speaker wires must exit through the bottom of the siren. The siren wire hole is also the drainage hole. Improper mounting will damage the driver and void the warranty. Sirens produces extremely loud emergency warning tones! Exposure to these tones without proper and adequate hearing protection, could cause ear damage and/or hearing loss!
(more…)
