Automotive Manual PDF

RSS Feed

The Resources for Automotive

2010 Hyundai Genesis Coupe L4-2.0L Turbo AEM Dryflow Filter Installation Instructions

March 24th, 2010 · No Comments

1. Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Disconnect negative battery terminal.
e. Jack up the front of the vehicle and support using properly rated jack stands.
f. Do not discard stock components after removal of the factory system.
(more…)

[Read more →]

2001 CR-V (EX) Cassette Player Installation Instructions

November 15th, 2009 · No Comments

1. If equipped, make sure that you have the anti-theft code for the radio, then write down the frequencies for the preset buttons on the radio.
2. Slide the driver’s seat completely to the rear.
3. Disconnect the negative cable from the battery.
4. Open the glove box. Squeeze the retaining tabs, and remove the stop. Pull the glove box down.
5. Remove the driver’s dashboard lower cover (two self-tapping screws, four retaining clips and one connector).
6. Remove the lower console cover.
(more…)

[Read more →]

1955-56 Ford Installation Instructions

July 9th, 2009 · No Comments

1. Disconnect Battery. Do not skip this step. Also, do not try to “test” the LED array by connecting the leads directly to your battery. Permanent damage will occur to the LED array if you fail to heed these steps. Handle the LED array by the stainless steel bracket, not by the LEDs or the supporting circuitry.
2. Remove taillight lens and gasket.
3. Remove taillight bulb.
4. Remove the bulb connector from the back side of the taillight. Cut the two wires close to this connector.
5. Install the provided wire guide into the bulb hole.
6. Route the supplied electrical harness through wire guide to the area where connections will be made. Note that the ground connection (green wire) is made through the LED array’s stainless steel bracket.
(more…)

[Read more →]

Brake Fluid Exchanger BFX-1 Operator Manual

October 16th, 2008 · No Comments

Verify that the Brake System does not have any malfunctions. If the system is found to be malfunctioning verify that the malfunction will not interfere with the exchange process. Perform all necessary repairs prior to exchanging.
1. Verify that the vehicle engine is off.
2. Verify new and used fluid tank levels. Add new fluid or empty used as required.
3. Verify that all Switches and Attention Lights on the BFX control panel are OFF.
4. Connect red (positive) clamp on power cable to red (positive) terminal on vehicle battery.
(more…)

[Read more →]