Automotive Manual PDF

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Unclip and remove the intake hose from the throttle body housing.
3. Carefully lift the air box out of the mounting grommets and remove from the vehicle.
4. Taking the necessary safety precautions raise the front of the vehicle and support it with axle stands.
5. Remove the wheel arch liner from the vehicle by removing the two screws and clips.
6. Remove the original air box intake hose from the vehicle.
7. Unbolt & remove the air box mounting bracket from the vehicle.
(more…)

[Read more →]

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Disconnect the air temperature sensor electrical connection as shown.
3. Unclip the battery cable from the air inlet duct as shown.
4. Loosen and remove the two bolts that secure the air inlet duct as shown.
5. Remove the air inlet duct.
6. Loosen and remove the four bolts that secure the air intake resonator.
(more…)

[Read more →]

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Loosen and remove the air cleaner wing nuts, then remove the air cleaner lid.
3. Disconnect the cold inlet tube and then remove the air cleaner base assebmly as shown.
NOTE: Some vehicles are equipped with and air injection check valve which is vented to the air cleaner assembly. On these vehicles, remove the rubber hose and clamp the provided filter to the check valve.
4. Loosen and remove the two bolts that secure the air inlet/resonator, then remove the assembly as shown.
NOTE: K&N recommends that you do not discard your factory air intake.
(more…)

[Read more →]