Thank you for purchasing the Comptech Icebox Cold Air Intake for the 2002–2003 Honda Civic-Si and 2001 – 2003 Acura RSX. All components have been designed and manufactured utilizing the latest in technology and materials. Comptech recommends that you read through these instructions before starting installation and that you use an Acura Factory Shop Manual to supplement these instructions. All Comptech products are intended to be installed by a professional installer. Always use jackstands to support the vehicle when a car lift is not available. Always work in a clean environment and use the appropriate safety equipment to avoid any potential damage or injuries.
(more…)
Honda Civic Si & Acura RSX Icebox Cold Air Intake Installation Instructions
November 13th, 2008 · No Comments
SUZUKI M50 & C50 BOULEVARD THUNDER Air Filter Kit
October 16th, 2008 · No Comments
We’re sure you’ll be pleased with the new level of performance you’ll experience. This kit should be installed on bikes with After Market Exhaust Pipes only and jetted, (not included). We recommend that an experienced mechanic perform this conversion. Use the appropriate Suzuki service manual for reference to complete jetting of carbs. Remember, gasoline is extremely flammable and can be explosive under certain conditions. Work in a well-ventilated area and clean up any spills immediately. Check for leaks before riding.
(more…)
SUZUKI 800 VOLUSIA Adaptor Kit Installation Instructions
October 5th, 2008 · No Comments
Congratulations on your purchase of the SUZUKI 800 VOLUSIA Adaptor Kit. We’re sure you’ll be pleased with the new level of performance you’ll experience. This kit should be installed on bikes with After Market Exhaust Pipes only and jetted, (not included). We recommend that an experienced mechanic perform this conversion. Use the appropriate Suzuki service manual for reference to complete jetting of carbs. Remember, gasoline is extremely flammable and can be explosive under certain conditions. Work in a well- ventilated area and clean up any spills immediately. Check for leaks before riding.
(more…)
2004 Pontiac GTO Lingenfelter High Performance Air Intake System Installation Instructions
September 22nd, 2008 · No Comments
First remove the plastic radiator cover on the front of the engine compartment using a flathead screwdriver and a pry tool. Use a screwdriver to pry the center nail of the push fastener upward about half an inch. The pry tool will then be used to fully remove these four panel pins and free the plastic panel from the body.
Next remove the air temperature sensor from the stock air tube, being careful not to harm the sensor. Set the sensor aside at this time, it will be re-used later.
(more…)
