Automotive Manual PDF

The MOR/ryde Rubber Suspension System is a unique and technologically advanced suspension. The uniqueness of the MOR/ryde suspension is in its:
1.100% Natural Rubber Springs
2.13-inch Wider Spring Center
3. Frame Attachment. Fore and Aft the Drive Wheels Without a Slip Joint
4. Side-to-Side Adjustability to Compensate for Unequal Cross-Vehicle Loading
(more…)

[Read more →]

The front control arm mounting pockets must be trimmed slightly to install the front crossmember (0 902). Make a cut mark along the front lower bottom edge of the pocket to be flush to the control arm mounting surface. Also, make a mark in line with the inside lower edge to remove the rounded corner from the lower plate (Fig 22). Cut the marked area of the control arm pocket and paint any bare metal to prevent corrosion.
(more…)

[Read more →]

1. Park the vehicle on a clean, level surface and block the rear wheels for safety.
2. Safely raise the front of vehicle and support with jack stands for safety.
3. Remove the wheels.
4. Measure and record the length of the exposed thread on the torsion bar adjusting bolts for later reference.
DRV__________ PASS__________
(more…)

[Read more →]

FRONT INSTALLATION
1. Park the vehicle on a clean, level surface and block the rear wheels for safety.
2. Safely raise the front of vehicle and support with jack stands for safety.
3. Remove the wheels.
4. Measure and record the length of the exposed thread on the torsion bar adjusting bolts for later reference.
DRV__________ PASS__________
5. Remove the torsion bar assembly.
(more…)

[Read more →]

This kit includes new braided stainless steel brake lines. Installation of these lines requires the entire brake system to be bled following the completed installation and prior to operating the vehicle. Consult your owner’s manual for the proper brake fluid to use for your vehicle. Fluid is not included in this kit.
(more…)

[Read more →]

FRONT INSTALLATION
1. Park the vehicle on a clean, level surface and block the rear wheels for safety.
2. Safely raise the front of vehicle and support with jack stands for safety.
3. Remove the wheels.
4. Measure and record the length of the exposed thread on the torsion bar adjusting bolts for later reference.
DRV__________ PASS__________
5. Remove the torsion bar assembly.
(more…)

[Read more →]

Pre-Installation Notes
1. Special literature required: OE Service Manual for model/year of vehicle. Refer to manual for proper disassembly/reassembly procedures of OE and related components.
2. Adhere to recommendations when replacement fasteners, retainers and keepers are called out in the OE manual.
3. Larger rim and tire combinations may increase leverage on suspension, steering, and related components. When selecting combinations larger than OE, consider the additional stress you could be inducing on the OE and related components.
(more…)

[Read more →]