Please test install this undertail BEFORE painting it. Even though we’ve tested our parts on designated bike models, it still may need slight modification to fit properly with other aftermarket parts.
Installation:
We highly recommend having a professional install this undertail. A dremel tool or similar is what we found the best to cut plastics.
1) Place bike on a rear wheel center stand.
2) Remove passenger seat and hardware which secure stock undertail section
(more…)
04-05 Honda CBR 600 F4i Fiberglass F13 Installation Guide
October 29th, 2009 · No Comments
Rocket Locker Side Rails Installation Instruction
October 25th, 2009 · No Comments
Upon receipt of the Rocket Locker, the casting and the light should already be assembled and wires should be fed thru casting.
Step 1: Feed wires thru hole in the oval gasket.
Step 2: Install Allen head bolts through the hole in Rocket Locker casting, plastic oval gasket, and rubber expander.
Step 3: Install threaded back plate on Allen head bolt. Snugly tighten the back plate against the rubber expander.
Step 4: Remove the tail light lens. To do this, open tailgate and remove the screws that hold the lens in place (refer to picture below). If you are not sure which screws hold the lens in place refer to your owner’s manual on how to replace tail light bulbs. Then release the tabs on the other side of the lens.
(more…)
Ducati Monster Bobbed License Plate / Signal Relocation Bracket - Redpoint Racing
January 26th, 2009 · No Comments
The relocation bracket is designed to fit all Ducati Monsters within the year ranges of 2000-2004. It may fit other years as well, but I cannot guarantee an exact fit as minor changes have been done throughout the years. The bracket is designed to replace the stock tail light/turn signal/license plate assembly and the rearmost section of the frame on which the stock assembly mounts. It is assumed that the sub frame has already been removed.
(more…)
