Automotive Manual PDF

The BLADE installs easily onto round 1 7/8” to 2” diameter exhaust pipes. Important Notice: In order to install the BLADE, your car must:
• have an exposed, straight tailpipe measuring 1 7/8” - 2.0” in diameter. Example: 2004 Honda Civic
• or, dual exhaust pipes where there are 2 mufflers, each with a single exhaust pipe measuring 1 7/8” - 2.0” in diameter. Example: 2007 Lincoln Town car (in which case 2 BLADES are required).
If your car does not have either of these exhaust configurations, then your exhaust pipe will need modification. This modification is very easy to obtain at any exhaust shop i.e. Meineke, Midas, etc. Simply ask the technician to modify your tailpipe to meet this specification.
(more…)

[Read more →]

Removal of stock system:
First using 15mm socket or wrench, remove four (4) nuts at flange located approximately under the passenger side seat. Remove rear exhaust from rubber hangers and remove the system from under the truck.
NOTE: If you have purchased the optional front pipe, Remove the stock front pipe on the truck by removing the exhaust hanger on the transmission using a 13mm socket, then remove the band clamp at the front of the pipe, then remove stock front pipe from the truck. ( Note: the band clamp will be re-used during the installation of your new MBRP system)
(more…)

[Read more →]

Removal of stock system:
First using 15mm socket or wrench, remove four (4) nuts at flange located approximately under the passenger side seat. Remove rear exhaust from rubber hangers and remove the system from under the truck.
NOTE: If you have purchased the optional front pipe, Remove the stock front pipe on the truck by removing the exhaust hanger on the transmission using a 13mm socket, then remove the band clamp at the front of the pipe, then remove stock front pipe from the truck. ( Note: the band clamp will be re-used during the installation of your new MBRP system).
(more…)

[Read more →]

Hardware kit sold separately, contact your local dealer/distributor for further information.
Removal of stock system:
Remove nut, with 15mm wrench or socket, from band clamp in front of muffler.
Remove rear exhaust from rubber hangers, remove bottom shock bolt at rear of truck &
separate the stock exhaust at the slip joint at the muffler.
Remove the muffler and tail pipe from under the truck, re-install the bottom shock bolt.
Remove extension pipe at flange using 15mm deep socket.
Remove down pipe, under the hood remove band clamp with 11mm at turbo then cut pipe in front of transmission cross member to remove.
(more…)

[Read more →]