Automotive Manual PDF

1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Disconnect electrical connectors to throttle body & factory intake tube. See Fig#1
3. Using a 10mm socket, remove two bolts holding throttle cable bracket to intake manifold. Retain bolts for later use. See Fig#2
4. Remove throttle cable(s) from throttle body.
5. Using a Phillips screwdriver, loosen hose clamp on factory intake tube & remove tube from throttle body & air box. See Fig#3
(more…)

[Read more →]

TO START:
1. Turn the ignition OFF and disconnect the vehicle’s negative battery cable.
2. Loosen and remove the air cleaner wing nuts, then remove the air cleaner lid.
3. Disconnect the cold inlet tube and then remove the air cleaner base assebmly as shown.
NOTE: Some vehicles are equipped with and air injection check valve which is vented to the air cleaner assembly. On these vehicles, remove the rubber hose and clamp the provided filter to the check valve.
4. Loosen and remove the two bolts that secure the air inlet/resonator, then remove the assembly as shown.
NOTE: K&N recommends that you do not discard your factory air intake.
(more…)

[Read more →]

Installation Instructions:
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner assembly.
3. Using 10mm socket remove (3) nuts and studs from front side of throttle body. (Ref. “C”)
4. Remove air cleaner mounting stud and bolt from throttle linkage bracket and save.
5. Install (2) linkage extension plates using (2) 5/16 x 3/4” flat head screws. (Ref. “D”)
6. Install air cleaner mounting stud (Refer to Step 4) using 5/16-18” nut and lock washer.
(more…)

[Read more →]

Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen clamp at intake manifold leaving clamp on hose.
3. Slide hose tube assembly back and insert power plate into hose.
4. Reinstall tube hose assembly making sure power plate is engaged in tube while locating and tightening hose clamp.
(more…)

[Read more →]

Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body intake assembly.
3. Remove (2) bolts & save from linkage bracket. (Ref. C)
4. Remove (4) bolts from the throttle body. (Ref. D)
5. Remove gasket and clean surfaces.
(more…)

[Read more →]

Installation Instructions. Read Me!
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove throttle body intake cover.
3. Remove air intake hose assembly.
4. Remove (4) bolts from the throttle body.
5. Remove throttle linkage bracket and save screws. (Ref. “B” & “C”)
(more…)

[Read more →]

1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Remove air cleaner assembly.
3. Remove (2) 8mm bolts from throttle linkage bracket and save. (Ref. D)
4. Remove (4) bolts from the throttle body. (Ref. C)
(more…)

[Read more →]

1. Remove Air Intake Assembly and intake box from throttle body.
2. Remove the 4 nuts and studs that mount the throttle body to the intake manifold.
3. Install the JET Power-Flo throttle body spacer using the new o-ring.
(more…)

[Read more →]