Removing steering column switch
Driver’s side airbag unit and steering wheel removed.
- Pull out steering column and tilt downward as far as it will go.
- Remove screws -1-(2x). Tightening torque: 2.8 Nm (25.2 in lb)
- Remove grip - 2-.
- Remove two Phillips-head screws -arrows-. Tightening torque: 0.6 Nm (5.4 in lb)
- Remove upper steering column switch trim -1-.
When installing, insert upper section into hooks on lower section, swivel downward and secure with screws
(more…)
Audi A6 Instrument panel pdf
June 8th, 2008 · No Comments
BMW Tightening Torques
March 21st, 2008 · No Comments
The maximum tightening torques are: Only applicable to shaft screws with metric standard and fine threads acc. to DIN 13, sheet 13 and nuts with height of 0,8 x d acc. to DIN 934 and only for a µ total = 0.125 (screws phosphatized, screws untreated or galvanized. Lubrication condition: unlubricated and also oiled). For cadmium-plated screws or nuts (µ total = 0.08 to 0.09) the tightening torque with screw material at the same level of utilization ca. must be 30% less than shown in the table. The values specified in this table apply to all screw connections conforming to the aforementioned conditions.
(more…)
