This bellhousing is designed to fit all 1965 and up 289, 302, and 351 W/C engines. You may use a 164 or 157 tooth flexplate. These are available from ATI in heavy duty and SFI versions with any weight configuration. This bellhousing can not be used with a 12″ diameter torque converter, but it can be used with 7, 8, 9, 10 or 11″ units. The torque converter bolt pattern must match your flexplate pattern.
(more…)
Ford 5.0 Bellhousing Installation Instructions
June 27th, 2009 · No Comments
2005–up Mustang “ENGINE START” Push-Button INSTRUCTION SHEET
March 15th, 2009 · No Comments
The following information describes the installation procedure for the M-11572-GT “ENGINE START” push-button into a 2005-‘08 Mustang.
STEP 1: Start by removing the (2) screws found at the rear of the center console underneath the armrest. (Figure 1)
STEP 2: Remove the trim plate which surrounds the Shifter Handle (Auto) or Shifter Boot (Manual). (Figure 2)
Note: Manual transmission applications will require removing the shifter knob first. This can be removed by simply unscrewing it in a counter-clockwise direction.
(more…)
