INSTALLATION NOTE:
• These instructions are for the left door visors, the same procedure applies to the right door visors.
• Be careful not to damage the glass run channels and body finish.
• The door visors are not designed to absorb shock or impact. To prevent damage, handle with care.
• This door visor kit should only be installed if the ambient air temperature is 60°F (15°C) or above.
• To allow the adhesive to “cure,” do not wash the vehicle for 24 hours.
• Follow the instructions shown on the caution label attached to the container before applying the primer.
(more…)
2004 TSX Door Visor Installation Instructions
November 19th, 2009 · No Comments
2009 TSX Front Aero Bumper Installation Instructions
November 14th, 2009 · No Comments
The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.”
NOTE:
• Be extremely careful not to damage the body.
• To prevent damage, rest the front bumper on a blanket or cardboard during the installation.
• Before removing parts, note their locations so that they can be reinstalled in their original locations properly.
(more…)
2004-2005 Acura TSX Figure Grille Set Installation Manual
November 10th, 2008 · No Comments
Acura TSX Figure Grille Installation
1) PREPARATION
1.1) Remove the OEM fog light grilles, if this item was purchased. The stock fog light opening covers are held in place with spring clips attached to the cover. Work a finger between the cover and the bumper, and pull outward to release the cover.
1.2) The lower center grille is not removable; it is bonded to the bumper, and it will be left in place.
(more…)
Figure’s 2006-Present Acura TSX Custom Grille set
November 5th, 2008 · No Comments
Scion xB Figure Grille Installation
1) Upper Center Grille
1.1) Remove OEM Grille. Begin by opening the hood. Remove the radiator cover that fits above the OEM grille. The radiator cover is held in place by a series of pop-top fasteners. Remove these by following the procedure shown in Figure 1. Finally, there are additional pop-top fasteners and two 10mm bolts that hold the OEM grille in place. Remove these and then remove the grille.
1.2) Prepare bumper for installation. Once the OEM grille is removed, drill two 1/8” holes in the locations shown in Figure 2. These holes will be used to secure the Figure Grille. If you ever need to re-install your OEM grille, these holes will be completely hidden and will not interfere in anyway.
(more…)
