Automotive Manual PDF

The tools you needs:
A drill with a smaller bit such as a 1/4″
A dremel or similar to cut a hole in plastic
T27 Torx bit and driver with 4” extension
Extendable magnet
Pliers

1. Take the kit out of the box and lay everything out. You can install either the ballasts or bulbs first but typically it is easier to install the bulbs first.
2. There are 3 T27 torx screws holding the headlight on. The 2 on top are visible in this picture.
3. with the 2 screws removed…
(more…)

[Read more →]

Turn signal
Illuminates when the left or right turn signal or the hazard lights are turned on. If one or both of the indicators stay on continuously or flash faster, check for a burned-out turn signal bulb. Refer to Exterior bulbs in the Maintenance and care chapter.
(more…)

[Read more →]

1. Park the vehicle on a clean, flat surface and block the wheels for safety. Place automatic transmissions in park and manual transmissions in neutral.
2. Remove the negative battery cable first, then the positive battery cable. If equipped, the Supplemental Restraint System will be deactivated when the battery is disconnected.
3. Measure and record the space between the bumpers and the body as well as the space between the cab and the bed for reference during installation of the kit.
(more…)

[Read more →]

1. Remove positive and negative battery cables. If equipped, the Supplemental Restraint System will be deactivated when the battery is disconnected.
2. Note the location of the front and rear bumpers in relation to the front/rear of the vehicle for use in alignment during installation.
(more…)

[Read more →]

Your third brake light kit was built to high quality standards to provide you with years of reliable service. This manual should serve as a guide for installing a third brake light kit on your vehicle. Although this guide is thorough, each installation is different, so it can not cover all applications. You can install the turn signal kit yourself IF: 1. you have the right tools, 2. you have a reasonable mechanical and electrical aptitude or experience, 3. you have the knowledge or diagrams of where wiring, fuel lines, etc. are located in the vehicle, 4. and you read and follow the instructions very carefully.
(more…)

[Read more →]