Automotive Manual PDF

Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor liner. However, do not remove the factory-installed carpeting. Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409о or Glass Plusо work well. Use of Armor Allо, Son-of-a-Gunо or similar items is discouraged as these products make the liner slick.
(more…)

[Read more →]

The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.”
NOTE: These installation instruction show the left fog light begin installed. The same procedure applies to installing the right fog light.
(more…)

[Read more →]

You have just purchased the finest turbo system available for the 6.9 and 7.3 liter diesel engine. The following information will assist you in the installation of your ATS turbo system.

IMPORTANT: It is very important to read all the instructions carefully prior to any installation of your turbo system. Normal mechanical and safety procedures should be followed.
(more…)

[Read more →]

The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.”
(more…)

[Read more →]

Please gather the following tools before you begin the installation: * Power Drill. * 3/16 drill bit. * Large flat head screw driver. * Large Phillips head screw driver. * Sharp utility knife or razor blade. * Fine permanent marker. * Center punch & hammer - optional. Step 2 - Unpack Dead Pedal kit and verify contents. Remove all items from the the shipped package. Copyright © 2003 Redline Tuning LLC. All Rights Reserved. You should have the following before beginning: * RedlineTuning Focus Dead Pedal * (2) Washers * (2) Sheet Metal Screws * Printed Installation Instructions
(more…)

[Read more →]

Gather required tools. Please gather the following tools before you begin the installation: * Power Drill * Utility Knife. * 3/16 drill bit. * Duct Tape * 9mm or 11/32 open ended wrench. * Pliers. * 9/64″ Hex Key or Allen Head wrench * Small piece of cloth. * Flat file for filing metal. * Zip tie - medium size. * Rasp file or round file. * Body color touch up paint. * Fine permanent marker. * Phillips screw driver. Step 2 - Unpack fuel door kit and verify contents. Check items you removed from the box. You should Copyright © 2003 Redline Tuning LLC. All Rights Reserved.
(more…)

[Read more →]

Tools & Materials Needed: 1. Utility Knife 7. Crank Spring Removal Tool 2. Wire Crimper (Special Tool, available at most 3. Torx™ Wrenches Auto Parts Stores) – or – 4. Hex Nut Drivers 8. Flat Screw Drivers (2) 5. Drill and Bits 9. Add-A-Circuit™ fuse adapter 6. Phillips Head Screw Driver 10. Silicon Sealant (Clear or Black) A. Removing the Door Panel Coverings 1. For ease of installation, do both sides at the same time. 2. Roll the windows to approximately 1/2 open, and so the crank handle is in the Down Position. With either the Crank Spring Removal Tool, or a flat Screwdriver, remove the spring, located in a slot on the back of the crank.
(more…)

[Read more →]